Clymit PoE Injector

The Level One, 1-port Clymit PoE Injector takes a 100-240VAC signal with a maximum current draw of 0.3A.

A straight-through CAT-5 cable can be routed from an Ethernet switch/router/hub into the "Data In" port on the Injector.

Output is a -48VDC signal carried to the Splitter unit via another CAT-5 cable.

Clymit PoE Splitter

The Level One Clymit PoE Splitter has the option of either outputting a 5VDC or 12VDC power signal from the -48VDC on the "Data In" port.

Set 5V or 12V with the dip switch located on the side of the unit.

The 12V setting powers a Clymit 200 unit.

Notes

• If your Ethernet switch has PoE – you will only need to deploy Clymit PoE Splitter to power your Clymit 200 over Ethernet.
• If your Ethernet switch does not support PoE – you will need to deploy both Clymit PoE Injector and Clymit PoE Splitter (Clymit PoE Kit) to power your Clymit 200 over Ethernet.

Cable Length

The specified maximum length of cable allowed between the Injector and the Splitter should be no longer than approximately 300 feet. The signal will start to degrade past this length.

Clymit PoE Injector

• Weight: 7.05 ounces
• Dimensions: 4.6 x 2.4 x 1.4 in.
• Combines 120VAC with data
• Output: CAT-5 cable up to 300'
• Power cord included

Clymit PoE Splitter

• Weight: 5.3 ounces
• Dimensions: 3.1 x 2.2 x 1.0 in.
• Separates power and data into barrel plug power) and Ethernet cable (data)
• Clymit 200 Power: Set the DIP switch on the side to 12V