Servit PX feature eight ¼-20 x 0.5" grounding studs on the inside of the four rails (two on each rail, one at the top and one at the bottom) used for electrical grounding. These studs allow you to ground your equipment directly to the stud or with the use of bus bars (purchased separately).

The racks also include serrated tooth washers to allow the frame to be grounded during the assembly process. The washers, when tightened, dig in and remove paint from the steel surface, establishing electrical continuity throughout the rack.

A wide range of available options allow customizing the rack environment, with integrated zero-U power strips, LCD consoles, keyboard and mouse accessories, environmental monitoring systems, shelves, and cable management.

• Rack-Mounting Height: 45U or 24U
• Rack-Mounting Width: 19" EIA rack-mount standard
• Rack-Mounting Depth: Variable, 26-38 inches in 1-inch increments
• Rack-Mounting Rails: Four, 2 in front, 2 in back, #10-32 pre-tapped holes
• Height: 84.12 inches (45U model); 47.37 inches (24U model)
• Width (External): 20.81 inches
• Depth (External): Variable, 35.04 to 50.04 inches in 1-inch increments
• Construction: 12 gauge cold rolled steel
• Weight: 97 lb (45U model); 68 lb (24U model)
• Weight capacity: 1600 lb
• Finish: Black powder coat
• Ships: UPS/FedEx

• Variable depth setup, determined by user on-site, between 26-38 inches in 1-inch increments
• 4-post, front and rear mounting support
• Stand-alone or networked (ganged together) deployment
• Supports floor bolting
• Open top design allows for smaller trunk cabling into the uprights
• 10-32 tapped rails
• 45U and 24U models
• 12 gauge cold rolled steel construction
• 1600 lb weight capacity
• Uprights feature cable pass-through holes to allow cabling to pass from one rack to the next
• Compatible with most ladder racks
• Ships knocked-down with UPS/FedEx in one box
• Easily and quickly assembled on-site
• Black powder coat finish